Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Honeycomb infill
#1
When I am printing something that is a little bit thicker , I do not have any infill in it.
There is no honeycomb structure while I have selected this in slic3r. I have taken the settings of Eduard in another thread here on the forum.
Any can help me with this ?[Image: image.jpg]
Reply
#2
If this happens with every model then I would delete the slicer installation and start fresh. Reinstall without anyone elses settings - and after you see it working you could try other peoples settings. It sounds like there is something is the config overriding.

Kieth
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)