Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repetier-Host settings
#1
Using Repetier firmware and Repetier-host?
What are your settings in Repetier-Host
Printer settings
Bed size, dump area etc
I don't have them right?
Anybody got them dialed in?

I have measured
Hard home is X=0 Y=0
Bed front (Back -Right) X=50 Y=30
(Back-left) X=240 Y=30
Bed Height (Front- Right) X=50 Y=220
Max Front-Left X=240 Y=220

Dump width 15 Dump Depth 30




:S[Image: Bed_Measure.jpg]
Reply
#2
X0 Y0 should be where the printing area begins (rear right corner). Use this settings with Repetier:

[img]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)