Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gluing
#1
Hello,

I'm using dollar store stick glue, it get dry quickly and filament do not stick to it. I wonder if it is related to bed temp(105) or the brand of the glue?


what are you using?
Reply
#2
I am using elmers glue stick, it is purple when it goes on then turns clear when the water evaporates. It is kinda nice because when you go to clean it off with water it turns purple again and you can see it really well. I am using 92 degrees on my print bed however.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)