Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LCD Readout & XYZMod
#1
Ive been using slic3r+XYZmod to run my Da Vinci for a while now, it is handy being able to adjust temperatures on the slicer side. However, when the printer gets to the line that tells the nozzle to heat up to 220 (vs 210 default) the LCD changes to show the current nozzle/bed temp. How do I trigger the display to go back to the Percent Complete/time remaining screen? (I know the time remaining is inaccurate, I am more interested in % complete).

Also, does the firmware ONLY track whole hours for the total machine run time? My machine shows that I have a total of 16hrs on the machine, but if i run a few jobs that only take 30minutes, I don't think the lifetime hours are increasing.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)