Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Z-Probe Stopped Working - Pads read 3.3 Volts reference to g
#1
I have been using Z probe successfully for a while now, until today. I took the printer apart to put more permanent shims on my y-axis pulleys, and when I put it back together, Z-probe no longer functioned. I've checked continuity of call associated cables, and they appear to be fine. The pads at the probe locations all measure about 3.3 Votls relative to the frame of the printer.

Any ideas? .... I'm hoping I didn't fry something....
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)