Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
This worked for me :-)
#1
Just for your information:
Maybe your config does not work, but this is what I have got working:

I've reset my original filament cartridge to 240m/230°C using the original software from mr Oliver Fueckert (https://github.com/voltivo/davinci_filam..._eprom.ino).
Then "downgraded" to xyz firmware 1.1E and using xyz 1.29.42 from this site.

So, now, using my "original" casette, I print perfectly with 230°C 3rd party filament and using my expensively purchased "after market" original xyz filament at original temperature 210°C.
Good thing is; all my cartridges shows 240 metres remaining, regardless. :-)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)