Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Modified .91 Repetier firmware verify problems
I've modified the firmware found here to work with the different Thermistor's I've installed on my printer.

I am very new to all of this and i'm trying to learn by finding information on the boards instead of asking but I can't find anything about this error and I think it might be and easy thing that the more experience users see and don't give a second thought because it's so easy to fix. I'm using the Arduino 1.5.6-r2 and have the atmel drivers installed and have successfully flashed the original Custom Firmware and the factory Firmware back and forth on the board. Where i'm running into a problem is when I've modified and tried to compile the sketch to upload I'm presented with an error.

Quote:Arduino: 1.5.6-r2 (Windows 7), Board: "Arduino Due (Native USB Port)"

In file included from /Configuration.h:42,
from /Repetier.h:117,
from Commands.cpp:22:
/pins.h:285: fatal error: userpins.h: No such file or directory
compilation terminated.

This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.

I have an E3dv6 and mk2b heat bed installed on my davinci 1.0 and ordered Thermistor's thinking they would work the same. I was wrong about that. The extruder would read at about 30 Celsius and the Heat bed would read at 80 degree's Celsius. I have ordered The Thermistor's on the Spare parts page, but I have been getting into flashing the firmware and would like to know a bit more about this world of 3d printing. I've attached the modified firmware I made using the .91 firmware customization. Any help would be appreciated.
well the answer is obvious you do not have userpins.h - you did not take the FW properly

/pins.h:285: fatal error: userpins.h: No such file or directory
i just about to delete this. As soon as i posted it clicked in my head and I moved it over and successfully flashed.

Forum Jump:

Users browsing this thread: 1 Guest(s)