Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Getting Y-axis bearings off of shaft on Da Vinci 1.0
#1
Hey guys,

My stock bearing holder cracked, and I opted to shim the little white gears, and can't get one of the bearings off of the shaft.

One came off with moderate force with a pair of needle nose pliers, but the other one feels like superman put it on. Amy ideas on how to get it off without ruining the bearing?

Thanks in advance.
Reply
#2
Strange, mine practically fell off when I removed the shaft.
Maybe try heating them a little to see if that will loosen them off ??
Davinci 1.0 with repetier 0.92 & E3D hotend
Slicer - Simplify3d 


Reply
#3
Since I found some replacements online I went ahead and used a crescent wrench to bang it off. It came off after a half-dozen wacks. Maybe it wasn't on quite straight?

Thank you!
Reply
#4
Please post link to source.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)