Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bed level adjuster mod
#1
Been finding the stock thumb screws a bit awkward to turn and difficult to gauge how much you've turned them so I knocked up these .... http://www.thingiverse.com/thing:526058.
They're much easier to turn and provide a visual aid to help judge the amount of adjustment.
Davinci 1.0 with repetier 0.92 & E3D hotend
Slicer - Simplify3d 


Reply
#2
Very nice! Too bad I have to level my bed right now. So I am screwed (no pun intended) till I calibrate the bed level.
Reply
#3
Very nice. Will make.
Reply
#4
Just got round to replacing my printers 2 rear thumb screws and realised the original adjuster is too short, doh ! :oops:
Apologies, I'm working on this just now and will upload a 2nd STL for the rear adjusters shortly.
Davinci 1.0 with repetier 0.92 & E3D hotend
Slicer - Simplify3d 


Reply
#5
Ok, I've uploaded a 2nd version of the adjuster to Thingiverse which fits the 2 at the back.
So use 1 of the short ones at the front and 2 of the longer ones at the back.
Once again, apologies to anyone who has already printed 3 of the original, shorter ones.
Davinci 1.0 with repetier 0.92 & E3D hotend
Slicer - Simplify3d 


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)