Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Any danger in using slic3r/hacked xyzware?
#1
Let me start off by saying i'm a total noob, i've had my davinci for about 6 weeks and have had mixed results, especially since using filament from other manufacturers. So I downloaded slic3r and the hacked xyzware so I can experiment at making minor adjustments. My question is, is there any dangers in using this? Such as my printer not recognizing the extruder or bed location and causing the extruder to hit the bed? Please let me know of any dangers and any slic3r options that would help me avoid them.
Reply
#2
One more question, do I set the z offset in slic3r under the printer tab to the same number my printer gives me after calibration?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)