Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Noob Questions
#1
Good evening,

I just bought one of these printers, and when it comes in I was planning on converting it to Repetier firmware. Before I do that, though, I wanted to ask about calibration using Repetier. Can any of you point me in the direction of a tutorial on calibrating it with Repetier?

Also, for the Repetier print from SD card features, do you need to physically remove the SD card or is it possible to transfer via usb?

I guess, the last question I've got is an opinion based question. I have an old reprap I need to make replacement parts for, do you guys think I should print those before or after switching to Repetier?

Thanks a bunch!
Reply
#2
prints via usb,
calibrate manually with piece of paper
print parts after
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)