Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding PLA Layer fan using extruder 2 circuit
Just share some idea about adding a layer fan for PLA printing.
I think by adding parts for E2 extruder for 12V fan control will be very easy to do.
[Image: E2Parts_display_large.jpg]
While you are fleshing things out, Can you look into what other parts are needed to be added to the board to make the second extruder fully functional?
Its in the works to add dual extruders.

That's all I can say right now. Give it a few weeks. Smile

Did anyone ever post a list of needed electrical components to enable the second fan control circuit on the 1.0A board?


Forum Jump:

Users browsing this thread: 1 Guest(s)