Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stock firmware - regarding filament remaining
#1
I am currently back to the stock firmware and am curious. Has anyone zeroed out the filament cartridge and tried printing a demo directly from the printer? Does it give an out of filament cartridge error (not talking about xyzware)? TIA
Reply
#2
Quote:I am currently back to the stock firmware and am curious. Has anyone zeroed out the filament cartridge and tried printing a demo directly from the printer? Does it give an out of filament cartridge error (not talking about xyzware)? TIA
I don't have an answer to your question, but you should probably put which version of firmware you are using, as that might make a difference vs other versions someone else may be using giving possibly different results..
Reply
#3
I am running 1.1.G and still have about 20m left before I will be able to find out. Big Grin
Reply
#4
It will report "Out of filament" On the lcd.

One of the earlier firmwares would compare gcode filament used to remaining and use that number to subtract from remaining - and anything greater than zero (000.001 meters remaining) would allow the sample to print.

Kieth
Reply
#5
Thanks Kieth!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)