Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
how to remove side panel
I have a problem with my y-axis motor tension. I want to take off the panel to investigate, but I can't figure out how--

I can pry the little tabs along the inside bottom of the panel a bit. but, the ones at the edge won't budge. and, it cant slide up because there are tabs from the panel in the vertical frame.

I found a video by xyz for how to make the adjustment.

but the panel is already loose in the video (which tells me it's a PITA). But, I don't want to break it. any suggestions?

Forum Jump:

Users browsing this thread: 1 Guest(s)