Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Octoprint/Cura setting DaVinci 2.0a duo
#1
I'm a newbee with repetier/octoprint.
And in can not make it work 100%
Is there some one how could help me with my printer settings.

I'm able too print with extruder Left/"tool 0"

Dual color printhead still has a 35mm offset while printing. Both extruders are printing

And too use just extruder right/"tool 1" to print is a mistery to me. Tried too edit the gcode but it will not work.

So if some one could share the printerprofile and cura settings it would help me a lot
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)