Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
help with correct "code" for 200m lenght
#1
First of all, THANK you so much. On my 1.1Plus I can now set hot end and bed temp as I wan't, and can reset length.

But I can not figure out the correct value for 200m as the PLA spool I use right now are that lenght, it would be nice to set it to that length and have the printer tell me if I do not have enought left for a print.

So is there somebody that knows the correct value for 200 meters? Huh
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)