Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Duo 2.0A flash architecture.
#1
I notice that the Atmel ARM chip has two 256K regions in it's flash memory.  I programmed a 1.0.b flash file I found somewhere but the printer does not boot to flash upon turnon.  Only have the two lines on the LCD.   I notice that the flash file is almost exactly 256KB.  Do any of our experts know if the 2nd flash region of 256KB needs to be filled with code?  If so, what flash file to programs it?  I used the Bossa programming method and selected "Erase All" and "Boot to Flash" when I programmed it.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)