Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Resetter question. Temps not accurate.
#1
I recently learned about resetting the cartridge using and arduino. 

One of my favorite things about it is its ability to adjust the temps. However when I set the temps to, lets say 90 on the print bed, the actual temp on the printer is more like 70.  And when I set the bt[] to 100, I see 80 real world.

Its the same issue with the extruder temps. At 230 I get 212-ish, at 245 its at 250-ish.

So my question is, is there a complete list of temperature codes that the firmware will recognize? Why is it a temp set in the code does not translate to the real-world temps on the printer?

I am doing this on a duo with 2.0j firmware if that helps at all.

thanks in advance.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)