Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DaVinci Pro 1.0 e3dv6 hotend flex problem
#1
So, while I was looking after my son who was ill yesterday I finally completed my E3DV6 conversion. I will say yes it prints better than stock. But one thing I have noticed. After printing out an item and you leave it for a little while then try and print again it jams in the nozzle. When I pull out the filament it is like its been warped at the hotend. Any Ideas on this please? Also I am thinking of replacing my stepper motor to one which will work with Flex as it still jams up.

The real question:  How can i stop it from jamming in the Stepper motor which is feeding in to the bowden tube?  Is there anything I can print out to help?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)