Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Slicer suggestions to print PVA support?
#1
Hello, 

Now that I got my 2.0 back up and running, I've been trying to find solid info on what slicer and mods I need to do to print supports with PVA out of the second extruder. Searching these forums led me to Mordiev's E3D v6 mods, and will be doing that. But I haven't really found anything about what slicer is best for this. 

I tried messing around in Cura 2.3, with the Ultimaker 3 settings, but I couldn't adjust bed size, so fairly sure that wouldn't work. 

Thank you!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)